Carbon-Composite
Karl-Benz-Str. 1-3
73550 Waldestetten
Germany
Tel: +49 (0) 7171 495 9891
Fax: +49 (0) 7171 404 952
eMail: info@carbon-composites.com
Skype: Carbon-Composite
Web: http://www.carbon-composite.com
Carbon Tubes >>> http://www.shop.carbon-composite.com/in ... 3&lang=ENG
Contact Details - Carbon Composite Tech (GERMANY)
- AdminMASTER
- Site Admin
- Contact:
- Go to Rifle: Feinwerkbau 800
- Country: United-Kingdom
- Where: London
- AdminMASTER
- Site Admin
- Contact:
- Go to Rifle: Feinwerkbau 800
- Country: United-Kingdom
- Where: London
Post
#2 Re: Contact Details - Carbon Composite Tech (GERMANY)
Just ordered 2 X 1000mm (1 meter) length carbon tubes; at todays exchange rate with PayPal...Just a tad over £100.00 > £100.95 incl. P&P to UK
NB: This is for the Fwb800 Alu stock project + Mick T. titanium air cylinder & carbon shroud ...
NB: This is for the Fwb800 Alu stock project + Mick T. titanium air cylinder & carbon shroud ...
Signature - https://www.instagram.com/pimpmyairgun/?hl=en
- AdminMASTER
- Site Admin
- Contact:
- Go to Rifle: Feinwerkbau 800
- Country: United-Kingdom
- Where: London
Post
#3 Re: Contact Details - Carbon Composite Tech (GERMANY)
Ok, am about to order a carbon tube from here: http://www.shop.carbon-composite.com/in ... 10112#10mm - 19mm
It's for the ATAMAN barrel...which at both ends are smaller diameter.
So the solution is to use calipers to measure both external diameters.
Either the barrel needs machining to remove excess steel , or (preferably) depending on measurement of both diameters, a carbon tube will be fitted & glued on no problemo *IF* the larger diameter is say, 15mm exact.
Says officially, Its a 15mm O/D. But the machine cut at both ends aren't even likely more than 0.1mm deep. I wonder
------------------------------------------------------------------------------------
Juan / "Hot Pellet" confirms larger diameter is 16.2mm in mid section
Smaller diameter is 16.1mm (as also confirmed by Juan) at both ends...
It's for the ATAMAN barrel...which at both ends are smaller diameter.
So the solution is to use calipers to measure both external diameters.
Either the barrel needs machining to remove excess steel , or (preferably) depending on measurement of both diameters, a carbon tube will be fitted & glued on no problemo *IF* the larger diameter is say, 15mm exact.
Says officially, Its a 15mm O/D. But the machine cut at both ends aren't even likely more than 0.1mm deep. I wonder
------------------------------------------------------------------------------------
Juan / "Hot Pellet" confirms larger diameter is 16.2mm in mid section
Smaller diameter is 16.1mm (as also confirmed by Juan) at both ends...
Signature - https://www.instagram.com/pimpmyairgun/?hl=en
Who is online
Users browsing this forum: No registered users and 0 guests