Bench rest wedge AHG 1027 MAX 300

[AdminMASTER]

credit: https://www.krale-schietsport.nl/en/ben ... x-300.html

http://ahg.anschuetz-sport.com/index.ph ... uktID=1052

With the AHG MAX 300 bench rest wedge it is possible to tilt bench rest adjustments in stages up to max 20°. The carrier of this bench rest wedge is provided with screws on either side to guarantee a parallel and solid guidance. The 3-piece front connection joint locks both rails in parallel or tilted position. A stabilizing bar (40 gram) with two weight rings (30 gram each) corrects the overall balance point of the rifle.

The AHG MAX 300 can easily be mounted onto the fore-end stock by sliding two slot nuts into the stock rail. The integrated supporting legs can be used as a bipod and the MAX 300 is adjustable in length, has a width of 60 mm and is suitable for rifles with UIT rail.

[BenGun]

Never been a fan of a bipod that brings the rifle that close to the bench.
It's not comfortable.

[Jon]

Noticed them the other month, so far not seen any copies made.
Wont fit the Ones or Hunter they need an expensive £300 ish adaptor.

Bipods only for standing rifle up.