credit: https://www.krale-schietsport.nl/en/ben ... x-300.html
http://ahg.anschuetz-sport.com/index.ph ... uktID=1052
With the AHG MAX 300 bench rest wedge it is possible to tilt bench rest adjustments in stages up to max 20°. The carrier of this bench rest wedge is provided with screws on either side to guarantee a parallel and solid guidance. The 3-piece front connection joint locks both rails in parallel or tilted position. A stabilizing bar (40 gram) with two weight rings (30 gram each) corrects the overall balance point of the rifle.
The AHG MAX 300 can easily be mounted onto the fore-end stock by sliding two slot nuts into the stock rail. The integrated supporting legs can be used as a bipod and the MAX 300 is adjustable in length, has a width of 60 mm and is suitable for rifles with UIT rail.
Bench rest wedge AHG 1027 MAX 300
- AdminMASTER
- Site Admin
- Contact:
- Go to Rifle: Feinwerkbau 800
- Country: United-Kingdom
- Where: London
- BenGun
- Go to Rifle: ISP,Pardini,Feinwerk
- Country: UK
- Where: Ramsgate
Post
#2 Re: Bench rest wedge AHG 1027 MAX 300
Never been a fan of a bipod that brings the rifle that close to the bench.
It's not comfortable.
It's not comfortable.
- Jon
- Contact:
- Go to Rifle: JH
- Country: UK
Post
#3 Re: Bench rest wedge AHG 1027 MAX 300
Noticed them the other month, so far not seen any copies made.
Wont fit the Ones or Hunter they need an expensive £300 ish adaptor.
Bipods only for standing rifle up.
Wont fit the Ones or Hunter they need an expensive £300 ish adaptor.
Bipods only for standing rifle up.
If a jobs worth doing, do it right or not at all.
Return to “*** GENERAL CHAT / DISCUSSIONS / NEWS ***”
Who is online
Users browsing this forum: No registered users and 4 guests