Hello again.
Just finished this little job.
Its a Ti' conversion for a BSA R10
Pressure test rig goes up to 100,000 psi. Ive destroyed a few tubes just to satisfy my own curiosity. I got a few standard tubes to explode at some point in the future just to get a comparison.
I'll be ordering a bunch of tube soon to do a HW100 conversion to get rid of them heavy stainless thing they come with.
Later all.
Sean.
Titanium tube conversion
-
bl
- AdminMASTER
- Site Admin
- Contact:
- Go to Rifle: Feinwerkbau 800
- Country: United-Kingdom
- Where: London
Post
#2 Re: Titanium tube conversion
Oh My ! superb craftmanship...love the way It tapers down...
That's actually ..beautiful...would be nice as a paperweight its so stunning
That's actually ..beautiful...would be nice as a paperweight its so stunning
Signature - https://www.instagram.com/pimpmyairgun/?hl=en
-
bl
Post
#3 Re: Titanium tube conversion
Yeah it worked out quite well.
The neck of the tube is same as a buddy bottle so i had to assume the stock was sculptured to fit. So i just made ths tube fit in the "shadow" of a 280cc bottle.
Ive still got it coupled to the rig so al take a few measurements before and after pressurisation and get some pics of the vernier to post.
The neck of the tube is same as a buddy bottle so i had to assume the stock was sculptured to fit. So i just made ths tube fit in the "shadow" of a 280cc bottle.
Ive still got it coupled to the rig so al take a few measurements before and after pressurisation and get some pics of the vernier to post.
Who is online
Users browsing this forum: No registered users and 1 guest