.png)
Credit: Spurlos 69 (Ukraine)
http://airgun.org.ua/forum/viewtopic.php?f=15&t=32872
Anschutz 9003 & Cylinder strip down- Part II
-
AdminMASTER
- Site Admin
- Contact:
- Go to Rifle: Feinwerkbau 800
- Country: United-Kingdom
- Where: London
- spartan
- Go to Rifle: isp spartan, airstre
- Country: england
- Where: walsall
Post
#2 Re: Anschutz 9003 & Cylinder strip down- Part II
Not many threads holding the cylinder end plugs in 
- SnowBall
- Country: Spain
Post
#3 Re: Anschutz 9003 & Cylinder strip down- Part II
what is this??
A regulator inside the cylinder??
A regulator inside the cylinder??
-
ConorCo
-
Jon
- Contact:
- Go to Rifle: JH
- Country: UK
Post
#5 Re: Anschutz 9003 & Cylinder strip down- Part II
It looks like an half hearted attempt at getting the power up.
Adding a reg inside the cylinder would either need an adaptor made up where cylinder screws in to or retain existing reg.
Its not the number of threads its the aluminium tube used, have two here now cracked and in date.
Looks like a long quick fill added but dust cap only shown.
Adding a reg inside the cylinder would either need an adaptor made up where cylinder screws in to or retain existing reg.
Its not the number of threads its the aluminium tube used, have two here now cracked and in date.
Looks like a long quick fill added but dust cap only shown.
If a jobs worth doing, do it right or not at all.
Who is online
Users browsing this forum: No registered users and 5 guests