Fwb 800 - Steel Sleeve & Barrel location..

[AdminMASTER]

from: http://www.pimpmyairgun.com/viewtopic.php?f=82&t=1391

See them wooden utensils in pot in background ? well, the handle was thin & long enough for me to insert inside the steel sleeve tube, in order to gauge where the actual barrel ends.

PRESTO ! Scotch tape & black marker pen...That gives you now an idea, relative to the whole rifle.

The action on itself weighs just under 2Kg ...so imagine fitting an identical carbon fibre shroud (and junk the steel one) ...Thats the next step.

[Delphinus]

If it's the 10mt barrel with 425mm (600mm sleeve) it has 1.1Kg the 600mm (680 sleeve) has 1.3Kg.

Only go for carbon fibre if is the real thing not those cheap Chinese tubes with more epoxy than carbon the good ones are matt.

I will go for Titanium.

[AdminMASTER]

If it's the 10mt barrel with 425mm (600mm sleeve) it has 1.1Kg the 600mm (680 sleeve) has 1.3Kg.

Only go for carbon fibre if is the real thing not those cheap Chinese tubes with more epoxy than carbon the good ones are matt.

I will go for Titanium.

Dont worry...you should know me by now ? Ordered this (2 X ) > http://www.pimpmyairgun.com/viewtopic.php?f=123&t=91 > already delivered to dah Titanium Guru ...Mr. M.T. ...who says (to paraphrase: "bloody quality good stuff " )

AND

getting an additional titanium duo set done...ie: titanium barrel shroud with matching titanium air cylinder ..