.png)
The ones i did after this were on the other end of the reg'.
Started making a duplicator. but lost interest as is the way
Got £300 worth of CNC linear rail n bearings gathering rust in the corner.
Later all.
Rapid Twin Air
-
blodnobbl
Post
#1 Rapid Twin Air
A project from a while back. Ended up using the add on frome to make just a nice light weight rapid.
This is the quick fill i made for it.
The ones i did after this were on the other end of the reg'. A tube rapid (40mm OD) n stock patern.
Started making a duplicator. but lost interest as is the way
Got £300 worth of CNC linear rail n bearings gathering rust in the corner.
Later all.
This is the quick fill i made for it.
The ones i did after this were on the other end of the reg'. A tube rapid (40mm OD) n stock patern.
Started making a duplicator. but lost interest as is the way
Got £300 worth of CNC linear rail n bearings gathering rust in the corner.
Later all.
-
bucketboy1954bu
Post
#2 Re: Rapid Twin Air
Blod, If you have any of those reg QF manfolds kicking about anywhere, I'll have one off you 
Bb
Bb
Who is online
Users browsing this forum: No registered users and 0 guests