Just started this today.
Grade 2 titanium 40mm OD x3mm wall thickness.
Its 660mm long so should give around 500cc.
Later, Sean.
40mm titanium tube
-
Ge
Post
#2 Re: 40mm titanium tube
Nice stuff mate. Can you make me a weight compared between the titanium and a steel tube?
-
bl
Post
#3 Re: 40mm titanium tube
Certainley will.
I got some Airarms replacments also. From memory the steel AA tube was around 440gram. And the ti (10") are 260ish.
I'll weigh the 40mm t'morra.
Later, Sean.
I got some Airarms replacments also. From memory the steel AA tube was around 440gram. And the ti (10") are 260ish.
I'll weigh the 40mm t'morra.
Later, Sean.
-
th
-
bl
Post
#6 Re: 40mm titanium tube
Chaars.
Yes Phil.I'll make the reg' as part of the adaptor.
Be all 1 piece. Its long way around it. But ultimatley the best solution.
Sean.
Yes Phil.I'll make the reg' as part of the adaptor.
Be all 1 piece. Its long way around it. But ultimatley the best solution.
Sean.
-
th
Post
#7 Re: 40mm titanium tube
If you put the reg inside the tube you get a massive pre chamberblodnob wrote:Chaars.
Yes Phil.I'll make the reg' as part of the adaptor.
Be all 1 piece. Its long way around it. But ultimatley the best solution.
Sean.
-
th
Post
#9 Re: 40mm titanium tube
but the total volume stays the same we can discuss this one on sundayblodnob wrote:But loose cylinder volume.
-
bl
Post
#10 Re: 40mm titanium tube
Update
Works out at a few cc over 500
The funny colour is where i anodised the threads so the threads dont gaul up.
A full carbon shroud going on it. Then Vince'll sell it.
Works out at a few cc over 500
The funny colour is where i anodised the threads so the threads dont gaul up.
A full carbon shroud going on it. Then Vince'll sell it.
Who is online
Users browsing this forum: No registered users and 3 guests