40mm titanium tube

[blodnob]

Just started this today.

Grade 2 titanium 40mm OD x3mm wall thickness.

Its 660mm long so should give around 500cc.

Later, Sean.

[Georgemagnum]

Nice stuff mate. Can you make me a weight compared between the titanium and a steel tube?

[blodnob]

Certainley will.
I got some Airarms replacments also. From memory the steel AA tube was around 440gram. And the ti (10") are 260ish.
I'll weigh the 40mm t'morra.
Later, Sean.

[thebunnygotaway]

Nice one Sean it will have a reg it it wont it

[bucketboy1954]

Outstanding work as always Blod

Bb

[blodnob]

Chaars.
Yes Phil.I'll make the reg' as part of the adaptor.
Be all 1 piece. Its long way around it. But ultimatley the best solution.
Sean.

[thebunnygotaway]

Chaars.
Yes Phil.I'll make the reg' as part of the adaptor.
Be all 1 piece. Its long way around it. But ultimatley the best solution.
Sean.

If you put the reg inside the tube you get a massive pre chamber

[blodnob]

But loose cylinder volume.

[thebunnygotaway]

But loose cylinder volume.

but the total volume stays the same we can discuss this one on sunday

[blodnob]

Update
Works out at a few cc over 500

The funny colour is where i anodised the threads so the threads dont gaul up.
A full carbon shroud going on it. Then Vince'll sell it.