Early Serial Number , but with cocking lever (not pin).
Steal deal as usual from German website
Gun has, unusually "F" stamped on the top of action block - the story was that this was in a glass cabinet display since 2000 and because of strict German laws, was castrated to 7.5J, and obligatory "F" had to be seen. Less than total 4000 shots in its lifetime; no matter, mint 15 year old Dommie, as new the day it left the factory
So originnally a 16J, per sticker, which can be revereted back to its full potential legal power limit.
Walther LG300 Dominator Alutec - Nbr 50074 *MINT*
- AdminMASTER
- Site Admin
- Contact:
- Go to Rifle: Feinwerkbau 800
- Country: United-Kingdom
- Where: London
- AdminMASTER
- Site Admin
- Contact:
- Go to Rifle: Feinwerkbau 800
- Country: United-Kingdom
- Where: London
Post
#2 Re: Walther LG300 Dominator Alutec - Nbr 50074 *MINT*
...from same seller...only 1
...so , again, Alutec or Laminate swap around depending what one feels like garden plinking on any given day - perfect set !
...so , again, Alutec or Laminate swap around depending what one feels like garden plinking on any given day - perfect set !
Signature - https://www.instagram.com/pimpmyairgun/?hl=en
- Sven
- Contact:
- Go to Rifle: Anschutz, Walther, ATOM
- Country: The Netherlands
- Where: Arnhem
Post
#3 Re: Walther LG300 Dominator Alutec - Nbr 50074 *MINT*
This rifle has the 7,5 Joule / 6 FPE pressure regulator as can be seen by the length of the regulator in the picture.
Factory 16 Joule Dominators have a longer regulator. The setup with the 7,5J reg will shoot at 16J when the reg pressure is increased by 10 bar (at 95 bar that is). Looks like the 16J hammer and hammerspring are still with the rifle.
Factory 16 Joule Dominators have a longer regulator. The setup with the 7,5J reg will shoot at 16J when the reg pressure is increased by 10 bar (at 95 bar that is). Looks like the 16J hammer and hammerspring are still with the rifle.
Who is online
Users browsing this forum: No registered users and 2 guests